The gm tuned port injection tpi kit includes two throttle body fittings.
Throttle body cable install.
The cable must be adjusted so it is pulled fully out at wide open throttle.
The other end is on the driver s side floor attached to the accelerator pedal.
The brass throttle body fitting with.
Install the opposite ends of the throttle cables to the carburetor or throttle body tightening the threaded ends of the cable guides into the cable bracket completely.
I also show how t.
To make sure disconnect the cable hold the throttle wide open with your left hand pull the cable fully out.
Yes from our first mustang 5 0l throttle body in 1988 to our latest auto truck units each bbk power plus series throttle body is designed as a simple do it yourself bolt on.
Loosen and remove the two 10mm bolts securing the bracket to the intake manifold then remove the cruise control and throttle cable from the bracket.
The aluminum throttle body fitting with two set screws fits early tpi systems up through 1988 fig.
In this video i show how to remove your old stock throttle and idle cables and install some beautiful braided lines from magnum shielding.
This throttle cable is designed to be cut to fit for your particular application.
Part 2 of 3.
One end of the throttle cable is located in the engine compartment attached to the throttle body.
The final step is to adjust the throttle valve cable.
In fact most can be installed in less than 30 minutes with basic hand tools.
Throttle body removal and installation.
Slide the cables barrels into the valve catches and twist the throttle tube slightly to check that the valves open and close properly.
Adjusting this cable is the most important step when installing a 700r4 4l60 or 200 4r transmission.
Throttle cables all lokar throttle cables are available in either stainless steel braided housing black stainless steel braided housing or black housing.
Locate the throttle cable.
1 2 and 3 for the component names.
Remove the throttle cable.
This video is not meant to be a definitive how to always consult a professional repai.
Can i install my own bbk throttle body.
This is usually done by either.
Disconnect the throttle cable at the throttle body.
Removing throttle cable from saturn s series throttle body.
Dislodge the throttle cable from the ball stud on the throttle body.
